Mooscoe

Activity 6
Writing a CNC Program

Objectives

When you finish this activity, you should be capable to:

1. Apply what you fork over learned to write a CNC designme using the CNC Editor in the MicroMill software package.

2. Enter that CNC course of study into the computer and save it.

3. Test your program graphically to discern if it is working as intended.

Purpose

Now that you have most of the preliminary exam work completed from the last activity, you are going to usance that worksheet to produce that project. If time permits you and your partner(s) can all cut place one of these projects.

Equipment

Daily Question Answer Sheet
Writing CNC mandate worksheet

New Terms and Commands

Feed Rate
Rapid Traverse
[BILLET
[TOOLDEF

Procedure

Step 1: Double click on the VR Milling Software pic to begin the MicroMill software. The
editor is the part of the MicroMill Software where programs are create verbally and/or changes to the
program are made.

You may not have noticed in the past, but each time you give-up the ghost up the VR Milling software, a blank file package is on the screen. In a previous activity, you loaded up a file into that window and used the MicroMill to cut break your design as the MicroMill followed the commands step-by-step.

STEP 2: Entering military post Size

The size of the billet is X=4, Y=3, and Z=.125.

1. The commencement ceremony command in your program is a BILLET command.



To enter a billet command correctly, you first must shorten the square bracket key [ on the keyboard, indeed type the word BILLET.

2. To enter the billet size, press the X key and then the 4 key and then hit the space bar.

3. Continue entering the Y and Z dimensions by pressing Y3 and Z .125

4. When finished, the first line of your program should look like the line below:

[BILLET X4 Y3...If you want to pay off a full essay, order it on our website: Ordercustompaper.com



If you want to get a full essay, wisit our page: write my paper